Any chance anyone has one piece of body trim they would sell? Had some work done and they did not secure good, must have fallen off on my way home.
or anyone know where I can find it in stock? I don’t mind buying the entire set just have not found in stock.
CMC body. 
Replies sorted oldest to newest
Unfortunatly, you may end up replacing all of that trim, just to get it all to match.
I just checked on NLA Ltd. and found a full set for $140.
http://www.nlaparts.com/store/...olished-p-22212.html
You could also try Sierra Madre and/or Stoddards to see what they've got, or even give Greg at Vintage Motorcars Inc. to see if they have one. (714) 894-1550
.
As Gordon says, Greg at VM may be able to help.
I found myself in that position once (when the old Vintage Speedsters was still in Hawaiian Gardens) and VS was able to send me a single trim piece that matched what was on my car.
Greg may be using the same trim that is on your car, but, if not, he knows the business well enough to likely recognize what you need and where to source it.
.
I can't tell for sure, but the ends of your trim do not look mitered like the genuine 356 trim, which usually means that VW Beetle trim was used instead of Porsche. Better photos f the ends would help determine this, but you can also look at the forward end of the door piece and it should be cut at a hard 45 degrees and the trailing edge of the front fender is undercut at the opposing 45, overlapping at the door gap. These ends are all very sharp, and have a capping piece precision cut and fit into the ends to close the trim up.
If your trim is more folded over and a bit domed to form a closed end then it is likely the VW stuff.
