Carb Linkage

I am hooking up a pair of 34 Weber ICT's. They are on short intake manifolds and came with a SCAT linkage setup. My problem is that the linkage binds against the fan housing on the 3-4 side and on the shroud tin on the 1-2 side. Can anyone make any suggestions on what linkage modifications might help or maybe a complete different linkage might work better? Any help would be appreciated.

CB Performance makes a good Cross Bar Linkage kit for Weber IDF carbs for $79.95.
I'm not sure if they sell the same kit for ICT's.
If you're interested in upgrading to Weber 40 IDF's, I have a set available with intake manifolds for $200 + shipping.

Dave

David,

If Tony Passes, I would like a shot at the 40's

Patrick

David,

I also tried sending you a note offline, but it was bounced back. You can send me a note too.

patrick@frieldesigns.com

David, thanks for the offer on the 40's but I just picked up the 34's and want to try to make them work. Sounds like you and Patrick can work something out.

Make sure you spec the correct linkage from CB. There is more than one available and itf you don't ask they will sell you the one that works with their manifolds. The CB manifolds are farther spread apart and end up in different location fore and aft. I learned the hard way when mating them to my set up (I can't recall the mfr of my manifolds). I ended up buying two different linkage sets form CB and had to use parts from both to make something work.

Mike

Mike,

Were you at Dunkels on Sunday? Saw a number of Spyders but nobody standing near them. If you were there, sorry to have missed you.

Bruce

No Bruce, just my luck I caught the virus that has been sweeping through here and spent the weekend lying around trying to recover.

Mike