im replacing the 160s with 150s. the 150s fit loose and wont stay in tube. am i supposed to spread them a bit or did CB send me the wrong ones.
Original Post
Replies sorted oldest to newest
im replacing the 160s with 150s. the 150s fit loose and wont stay in tube. am i supposed to spread them a bit or did CB send me the wrong ones.
Bob......Assuming they are the correct jets, you may spread them oh so slightly....the "seal" of jet to stack occurs when the jet stack is lightly torqued into the carb body....Hope this helps...
leon, thanx. what is best way to spread them, maybe use a drill bit and pry on the jet a little.
Bob---just take a screwdriver and spread 'em. Also sometimes you get main jets that are too spread to fit into where they go and you have t9o mash 'em a bit so they will fit into the holder.