Skip to main content

I'm assuming metric thread? I have two nice door handles but the screw thread on the small end is screwed up on both. I took them to a real hardware store (rare) and tried to match the thread with US and metric but I don't want to screw them up any further. I'll but thread chasers if I can figure out what they are.

Original Post

Replies sorted oldest to newest

The ones on my CMC have #10 standard roundhead machine screws threaded into them. Both door handles were loose at the small end and the passenger side head was boogered up so I thought it was metric and tried the appropriate size metric but it wouldn't thread in so I then tried a standard #10 and it went right in.

 

I just confirmed in the CMC build manual and it says "#10 1/2" roundhead machine screws"

 

Hope that helps...Gary

Post Content
×
×
×
×
Link copied to your clipboard.
×
×