Could the owner of a CMC with the optional roll bar take a angle measurement for me? The best tool to use is a angle finder if you have access to one.
Thanks, Joe
Original Post
Replies sorted oldest to newest
Could the owner of a CMC with the optional roll bar take a angle measurement for me? The best tool to use is a angle finder if you have access to one.
Thanks, Joe
Thanks, Joe
Joe,
The rollbar leans back somewhere between 12 & 14 degrees. I tried measuring several ways. The results were generally in the 12 degree range.
The Main hoop as you look from the side of the is on the same plane (has no bends).
Looking at it from the front of the car, the main hoop angles in on each side around 15 degrees at a bend about 6 inches from the mounting plate (near the bottom)
The view in the photo is looking at it from the Side, measuring the angle it leans back.
It's hard to see the graduations on the combination square, but it's 14 degrees in this photo. (copy to a graphics application and Zoom in if you want to see it better)
Greg B
The rollbar leans back somewhere between 12 & 14 degrees. I tried measuring several ways. The results were generally in the 12 degree range.
The Main hoop as you look from the side of the is on the same plane (has no bends).
Looking at it from the front of the car, the main hoop angles in on each side around 15 degrees at a bend about 6 inches from the mounting plate (near the bottom)
The view in the photo is looking at it from the Side, measuring the angle it leans back.
It's hard to see the graduations on the combination square, but it's 14 degrees in this photo. (copy to a graphics application and Zoom in if you want to see it better)
Greg B