CMC Traditional Bathtub Speedster

Is there anyone that has assembled a CMC Traditional Speedster Kit,that still has the parts included in the kit list? Particularly,I want to know whether the kit included the belt line trim and up-shine license plate light.Anyone with this information please contact me,especially if you may still have the parts list.
Happy Motoring,
Al

Go to Library, it has the complete CMC 55 Speedster Build book.

YES - those parts were std in the classic body kit. The body side moulding was a roll of silver/chrome generic plastic stuff used as aftermarket door ding protector. Peel off the backing tape and stick it on. (Sure I still have if interested as I didn't use it - contact me if interested and I'll find it). Any auto trim shop or JC Whitney should have it. Better aluminum stuff is available from replica vendors. The license plate light is same as used on others (rubber is not a great fit to body out of the box on original). I've seen them on ebay but check with the replica vendors listed here to make sure you don't over pay.

You may have already ID'd it, but the Library is on the tabs above. You can also check our knowledge section, and use the Want Ads to seek parts, plans, etc.

(Alan?)

Al I still have the complete listing of CMC parts invoices

To All,
Thanks for the input.I found the answer that I was looking for in the "Library Section" under the CMC Manual.It is very clear and concise.
Al-ca-traz