I was hoping someone could give me some guidance. I purchased the DD Odyssey Series 2 CHT and Oil temperature gauges. I don't think they are reading correctly. I put the temp ring on #3 cylinder and the oil senors on the Type 3 block-off plate. I double checked the setup to make sure they were both reading in F degrees. After driving the care for 15 minutes getting it nice and warmed up with spirited driving, both temps seem low. The CHT never gets close to 200 F and oil stays around 150 to 165. I did quick temp measure with a candy thermometer in the dip stick and read 199. At the gauge end I have both gauges sharing a power and ground line, if that matters. I am not running any external cooler and do not have the extended sump but do have an external filter. Any thoughts?
Original Post
Replies sorted oldest to newest