Skip to main content

Replies sorted oldest to newest

Fred,
I don't have a picture, but I can give you a quick description. It is about two inches long. It is arched to fit inside of the upper headlight hole. It is about 1/2-3/4" deep. It has two holes for the rivets or screws that go into the headlight bucket. The lip that the headlight sits on is about 1/4" tall, and obviously follows the same arch. It was made of pretty lightweight aluminum, probably only 1/16 thick or so. You may be able to get some lightweight 3/4" aluminum angle stock, and then make the curve and trim the lip.
Sorry for no pictures, hope this helps.
OK. So I looked in my garage and found that I have a spare bracket from my CMC build.

If someone would like to send me their address, I would be more than happy to send this to them.

You could then presumably use it as a guide for making any others you might need.

Let me know.

Jim.


Wolfgang,
If you are talking about the piece of flat metal that has the bend in it that the 2 bows bolt to, I need one. Appears the kit that I have only had one in it. Send me an e-mail at "jander1965@cox.net" with your address to send payment to.
Fred, I have a plate bracket in the garage just laying around. It appears to be the same one that is used on the VW, pretty universal. I will see if my wife can locate it and get it to you.
Thanks,
Jim
Post Content
×
×
×
×
Link copied to your clipboard.
×
×