Skip to main content

Replies sorted oldest to newest

I molded fiberglass mountings and glassed them in on lower  the right hand  side under the seat. Models were made from non corrugated card board and covered with 4 layers of glass. Removed as much of the card board as was practical. My switches were round type with hi and low settings. It's easy to do and easy to reach.

You can't see them.

https://www.dropbox.com/sh/cku...Gmo-pSWL4DDgq5a?dl=0

Last edited by Jim Gilbert - Madison, Mississippi
Post Content
×
×
×
×
Link copied to your clipboard.
×
×