i'm a fabricator from long beach that was "blessed" with a kit from fiberfab that hung in my shop for years. lots of years since i don't like the fiberglass dust all over and in my shop.
dusted it off and built it for me in three months. widened the rear end of the car 4 inchs so i could tuck the bus transmission and swing axle under it without sticking flares on a perfect body.
the windshield took me 4 days to hand cut and sand to fit the body, i racked it back about 10 degrees and cut 3 inchs off the bottom to get it lower in profile.
it a nice example of the custom work that can be done and i need to know where is the best place to sell it?
it's 2010cc and disc/drum, custom made seats and reinforced pan, so the seats won't pop out in an accident.
thanks in advance for the help,
general francisco franco (ret)
Original Post
