Isolaters needed for fuel Facet fuel pump

I need some quarter-twenty isolators for my fuel pump. I need the type with two shafts which don't connect and are molded into a rubber stopper, if anyone's got a lead on where to go.
Purpose will be to stop the electric pump from yammering through the car's chassis when I install it.
I'm going to try the Fastenall warehouse near me.

Cory,
I use 5/16" bolts with rubber grommets under the bolt head and between the chassis washers/nuts.
A piece of soft rubber (layered inner tube will work) as a base pad between the pump and chassis will also help to quiet the rattle/hum of the pump.
Fastenall almost always reguires that you buy 100 pcs of must anything that they stock.

Thanks, Alan. I'll let you know how I make out.
You know that looking for little bits like this mean I'm almost done, right?
I'll be driving through Chambersburg on purpose as I shake the old girl down -- I'd love to see you.
Everything go okay this week at JH?

Cory,

That would be great I would like to lay my eyes on the speedster! I am 5 minute off of Rt 81...whan do you plan to run?
Met and discussed my woes with my Neurosurgeon on Thursday, my back & neck surgery is set for next week, Friday the 13th .....what luck huh ?
I have a top of the line professor in the neuro dept at Johns Hopkins, he said nothing to it, I do have confidence in him but then again as the old saying goes "It's not his neck that is sticking out" !

Alan, I'll be working in Arlington for three straight shifts from Friday at 7 a.m. through Monday at 7 a.m. so I can have off Tuesday, Wednesday and Thursday of this week to finish this car up. I have no idea when I'm going to cruise, but it looks like the end of the coming week -- just in time for your surgery and in the nick of time to go back to work using it for the commute.
No telling, though. It's the Wrench. I'm cautiously optimistic at the rate he's working now.
Will you be laid up there for any length of time? When are you coming to town? PM the cory.drake AT fmmc.army.mil account if you get time.

Cory,
CIP1 has the stand-offs:
http://www2.cip1.com/ProductDetails.asp?ProductCode=C13%2D9259

Greg

Cory...I used the hangers like CIP has to hang my oil cooler. The load was in shear rather than compression on the mounts and they broke, studs pulled out of the rubber. Not sure if the heat from the cooler was instrumental or not. Am using bolts through shock absorber grommets now. Just FWIW

Another source is Harley Davidson.
The passenger seat back is attached to the tour pack on UltraGlides via similar hangers. They are WAY better quality.
The H-D hangars are what I used to mount my external oil cooler.
Greg

Thanks! I'll be off to Harley of Annapolis Tuesday morning!

Good luck Alan...


Michael