I purchased a CB Camber Compensator for my Beck Speedster and discovered the side cover studs on the differential housing are too short. I contacted CB and Rancho, who built the transaxle, to no avail. Can anyone suggest a supply source?
Thank you,
John
Replies sorted oldest to newest
There’s nothing magic about them, so I would just double-nut a stud and turn it out, then get a replacement Metric stud at an Ace Hardware store or McMaster-Carr. I can’t remember the size so you’ll have to test one to see what they are.
Here’s a link to McMaster-Carr for threaded studs.
https://www.mcmaster.com/threa...ding~fully-threaded/
Unfortunately the longer case studs don’t come with the CC. I did as Gordo suggested and just removed one of the current studs and went to the hardware store, matches it up, and got some new ones.
The thread is 8mm x 1.25. I replaced a couple in my trans side cover area for a slave saver, aluminum bracket to shim the slave cylinder for a straight pull from the clutch arm.
Racer73, you should be OK if you get studs about 10mm longer than your existing ones. I also changed a couple on the other side by the starter for the battery ground and an extra ground strap.
Thank you Gordon, Robert and Danny!! I really appreciate your helpful input.
John
