Skip to main content

My body came without cutouts. Also, the rear apron is flush horizontally so there is no lip tucking under... Anyway, what I need are measurements for the slots on center and some measurement down from bottom of engine hatch? Are there any detailed drawings on the site? Thanks, Jeff.


PS I will also have to figure out the front horn holes and turn signal holes
Original Post

Replies sorted oldest to newest

My body came without cutouts. Also, the rear apron is flush horizontally so there is no lip tucking under... Anyway, what I need are measurements for the slots on center and some measurement down from bottom of engine hatch? Are there any detailed drawings on the site? Thanks, Jeff.


PS I will also have to figure out the front horn holes and turn signal holes
I laughed when I got my new CMC in '89 and build manual talked about scribe marks molded into the body. DRCLOCK said some of early castings out of the mold actually had the marks but nothing was on later ones. Did you look in the CMC build manual at least for the bumper measurements? Measure twice - cut once!

If your body looks like mine - I can do some measurements to add to photos. I have bumpers mounted now so can upload photos of those too. (Mine is a CMC classic body).

Here's quick front measurements for frt horn/turn signal:

3.5" down from center of headlight mtg hole and .5" in towards center of car for the center of the turn signal light.

17" in from center of car to where the horn grill cut out starts.

Make a cardboard templat of grill and light together and play with getting it level.

Attachments

Images (3)
  • Lf Lucas
  • Rt Lucas
  • Both l594 amber bulb
Post Content
×
×
×
×
Link copied to your clipboard.
×
×