Skip to main content

In a post over a year old I read this from Jack Moore
"Here are my thoughts... If you have gel coat, it is like sanding concrete, but it is hard. If it just lacks gloss, sand it all over with 1500, then 2000, then get a big, real buffer and buff it with a microcut and glaze. something that will remove scratches above 1500. Now, if you want a serious new shine, take and sand that gel coat with 220, then 440 with a DA, or random orbital sander. Then take a sanding block and wet 600 sand it, then sand it with 1000 and 1500. Now go spray a urethane sealer, then a solid urethane color coat, then 4 coats of urethane clear coat. Wait a couple of days and take 2000 grit wet sandpaper on a block to that clear coat. Then take a micro cut compound and glaze to it with a powerful buffer. You will take all that orange peel out of the urethane and make it look a quarter of an inch deep."


I started to wet sand with 220 and it is like sanding concrete. Do you guys do this by hand or use a machine? How do you know when you are ready to go to the next grit?
Original Post

Replies sorted oldest to newest

In a post over a year old I read this from Jack Moore
"Here are my thoughts... If you have gel coat, it is like sanding concrete, but it is hard. If it just lacks gloss, sand it all over with 1500, then 2000, then get a big, real buffer and buff it with a microcut and glaze. something that will remove scratches above 1500. Now, if you want a serious new shine, take and sand that gel coat with 220, then 440 with a DA, or random orbital sander. Then take a sanding block and wet 600 sand it, then sand it with 1000 and 1500. Now go spray a urethane sealer, then a solid urethane color coat, then 4 coats of urethane clear coat. Wait a couple of days and take 2000 grit wet sandpaper on a block to that clear coat. Then take a micro cut compound and glaze to it with a powerful buffer. You will take all that orange peel out of the urethane and make it look a quarter of an inch deep."


I started to wet sand with 220 and it is like sanding concrete. Do you guys do this by hand or use a machine? How do you know when you are ready to go to the next grit?
Read up on high-fill epoxy primer and block sanding (blocking). Goal is to smooth out the ripply gel coat (especially where you see the fiberglass cloth thru the gel coat) and give paint teeth to grab to.

http://ezinearticles.com/?Prepping-a-Fiberglass-Street-Rod-Body-For-a-Show-Quality-Paint-Job&id=1961372

http://www.rodandcustommagazine.com/techarticles/car_paint_fiberglass_preparation/index.html

Post Content
×
×
×
×
Link copied to your clipboard.
×
×