Classified postings do not allow for discussion (replies are not allowed). Direct message the member if you would like to discuss the item.
The Classified section is open to any individual (non-commercial firms) posting of items for sale. Members posting commercial advertisements must be enrolled in a Supporting Merchant program.
Postings without relevant details (PRICE, location, condition, etc.) will be deleted.
NOT MINE. I recently ordered one directly from QuickJack for $795 shipped. It's "open box" and last years model. $200 off MSRP. FEDEX delivers mine tomorrow!
Here's one on Miata forum w/pu in Roanoke, VA for $700. So save set-up and $95 if you are nearby.
https://forum.miata.net/vb/showthread.php?t=627477
Replies sorted oldest to newest
Wolfgang... how are you liking it?
I made some blocks to fit in the square holes to allow for the rubber pads to sit 1&1/2 inch higher and make sure the side bars did not touch the frame of my car. In your case with a pan it might not be an issue. Ray
You guys that live close by ... should look at it...
Mine doesn't arrive until tomorrow - then need to set up in my barn and feed it AT fluid and bleed it. Fortunately, back up to 75 degrees tomorrow. Now that's the FL I moved to.
Is there enough clearance to pull and engine-trans--front beam?
It gives you 20-22 inches give or take.
Wolfgang:
I'm available to help you set it up next week if you need it.
Bob
Greg, I have been wondering what you are going to lift?
His Miata
I have to hand it to Wolfie, though.....Putting your workshop/garage 1-1/2 hours drive from the house certainly reduces interruptions when you're working, huh?
