I am looking for an unfinished non-flared speedster project. I have previously built one. I am in the middle of rebuilding a Type IV motor and need a ride for it.Thank you.
Original Post
Classified postings do not allow for discussion (replies are not allowed). Direct message the member if you would like to discuss the item.
The Classified section is open to any individual (non-commercial firms) posting of items for sale. Members posting commercial advertisements must be enrolled in a Supporting Merchant program.
Postings without relevant details (PRICE, location, condition, etc.) will be deleted.
Replies sorted oldest to newest
I am looking for an unfinished non-flared speedster project. I have previously built one. I am in the middle of rebuilding a Type IV motor and need a ride for it.Thank you.
Hello Steve,
I was in the process of purchasing a fiberfab non-flared speedster as a second car. I currently have a 1957 CMC flared speedster that is about 75% complete.
Car Details:
1955 speedster w/precut pan
body,with doors,hood and trunk lid pre-hung
new wiring harness with fuseblock
complete interior w/conv top still in bag
windshield, steering wheel with hub
rollbar,headlights,taillights, mirrors,chrome, instruction manual ect.
The tail lights looked a little pitted from the pictures.
Welding for bumper mounts and body mounts are completed.
Pan cut to 11.81" with a 1600cc w/trans already mounted.
Holes for dash are cut already.
Holes for front and rear lights are cut already.
The Engine has not been run for 4 years???
There is rust on the pan but I am not sure how much yet.
I believe he told me it does have a registered VW title 1960s?
I am hoping to go to see the vehicle for purchase. He has sent me pictures already.
I might be able to let this one go only because I might not have enough room with my other car not finished?
I figured I would buy it anyway and maybe sell it in the future.
I was only searching because I also wanted a straight body type.
where are you located?
What are you looking to spend? maybe I can sell at a reasonable price.
You can reach me directly at john.wodecki@afco-sc.com or call me at (864)-231-1392
Thanks,
John
I was in the process of purchasing a fiberfab non-flared speedster as a second car. I currently have a 1957 CMC flared speedster that is about 75% complete.
Car Details:
1955 speedster w/precut pan
body,with doors,hood and trunk lid pre-hung
new wiring harness with fuseblock
complete interior w/conv top still in bag
windshield, steering wheel with hub
rollbar,headlights,taillights, mirrors,chrome, instruction manual ect.
The tail lights looked a little pitted from the pictures.
Welding for bumper mounts and body mounts are completed.
Pan cut to 11.81" with a 1600cc w/trans already mounted.
Holes for dash are cut already.
Holes for front and rear lights are cut already.
The Engine has not been run for 4 years???
There is rust on the pan but I am not sure how much yet.
I believe he told me it does have a registered VW title 1960s?
I am hoping to go to see the vehicle for purchase. He has sent me pictures already.
I might be able to let this one go only because I might not have enough room with my other car not finished?
I figured I would buy it anyway and maybe sell it in the future.
I was only searching because I also wanted a straight body type.
where are you located?
What are you looking to spend? maybe I can sell at a reasonable price.
You can reach me directly at john.wodecki@afco-sc.com or call me at (864)-231-1392
Thanks,
John