Skip to main content

I have a vinyl tonneau cover that came with my replica. The cover only has half the female snaps on the back end installed. The male snaps are installed already on my CMC speedster (complete, under the windshield too). They match up with the convertible cover perfectly.

 

The tonneau cover snaps (female) seem to be off and do not line-up with the studs on the car. Any way I can change the location of the female ones on the cover? Or am I out of luck?

1957 CMC Speedster Wide body.

Last edited by Scott57
Original Post

Replies sorted oldest to newest

You could try to Dremel out the mushroomed part of the female snap that holds the two halves together, separate them, realign a new snap and install.  If the old holes aren't too big you may not notice too much. How far off are the snaps from the male parts on the car already?  This may at least be a stop-gap until you get something else.  There is a guy on eBay that sells vinyl tonneau a for around $100.00.  I've thought about it but wonder how much I would really use one anyway.....

Frank

Originally Posted by Frank C.:

You could try to Dremel out the mushroomed part of the female snap that holds the two halves together, separate them, realign a new snap and install.  If the old holes aren't too big you may not notice too much. How far off are the snaps from the male parts on the car already?  This may at least be a stop-gap until you get something else.  There is a guy on eBay that sells vinyl tonneau a for around $100.00.  I've thought about it but wonder how much I would really use one anyway.....

Frank

The back half (rear) are only where the snaps have been installed (from driver door, going around the back to the passenger door). The misalignment starts about half-way around. Starting from 1/2" to almost 2" when you get to the passenger door.

 

I took the cover to a local automotive/upholster store and the owner said the easiest and cheapest way to fix is to just install new snaps where that should go. Leave the snaps that are off alone. I will end up having double snaps (side-by-side) just in the rear where they were off. The rest of the cover has no snaps so I can install those correctly.

 

Only trying to salvage the cover for now since it came with the car. I would want either a half boot or tonneau to cover the fold-up canopy. That canopy started to flap and move in the cabin when I was on the highway the other day.

 

Post Content
×
×
×
×
Link copied to your clipboard.
×
×