Greetings,
I want to install a rubber seal on my trunk. I'd taken earlier advice and added 1/4 sticky chair leg skid protectors but need a little more cushioning.
I have a FiberFab body. Has anyone worked out what I'd need size/configuration wise to work?
Thanks in advance for your advice.
Marshall
Replies sorted oldest to newest
I've searched the web. There are stickyback Ds and others with a slit that fits onto the edge of the fiberglass opening. I think that the slit one would have a more finished appearance over the D types?
Marshall
Here is a trim seal with "side" bulb. Is this close?
Marshall
@Marshall that lip around the frunk opening can be a. Thick, b. Uneven and c. Set back a bit from where the weatherstrip needs to go. I don’t know of anyone with a CMC/Fiberfab using that version. Instead, we mostly use the “D” type with a stick-on backing. You’ll need to figure out what gap you need to fill wi5 the D tube, but enter this description on Amazon - It should be really close to what you need.
Front trunk aka "Frunk" use a D shaped hollow seal from McMaster Carr Part # 93085k525 it's 5 /8" x 3/8" 3Mself adhesive thin wall D molding.
Phone: 330- 995 5500
Engine decklid: Do not use any type of rubber seal just the " buttons " as you want as much air as possible to exit the engine bay .
@Marshall
Marshall, here is some visual reference to the type of seal referred to by @Alan Merklin.
I used this on my VS. Use one length of this seal to completely circumnavigate the trunk (frunk)...
...with the ends coming together at the front bottom of the trunk edge.
Hope you find this info useful! 
Bwaaaaa Haaaaa! 
