Hello Everyone, I am looking for drilling templates for a Fiberfab (early 80s) body that was never completed. Any information regarding windshield installation is also welcome. Thanks in advance,
Replies sorted oldest to newest
I got them faxed to me years (and years) ago from CMC. They weren't very precise - I added the measurements.
There are complete windshield installation instructions under the "Resources/Knowledge Base" tabs at the top of this page, although you must be a donating member to access them.
I have post dummy fixtures:
In addition to the Greg's template, Gordon's and mine windshield instruction here. I have a set of dummy windshield posts, I cut the long female tub from and replaced that with a centered screw head. Set the post against the windshield frame sliding it down to the cowl, the screw head marks the exact hole center position... drilled hole is the same angle as the post base. ....You pay postage both ways. (Best #20 you'll spend building your speedster) Msg me: Alan
BTW does anyone have a 3D Printer? These post fixtures could be rum off for others to use and forward to each other.